Filter
Top Products
Appendix D: Industrial Devices
63
Checkpoint
Code
Description
82h
The keyboard controller interface test completed.
Writing the command byte and initializing the circular
buffer next.
83h
The command byte was written and global data
initialization has completed. Checking for a locked key
next.
84h
Locked key checking is over. Checking for a memory
size mismatch with CMOS RAM data next.
85h
The memory size check is done. Displaying a soft error
and checking for a password or bypassing WINBIOS
Setup next.
86h
The password was checked. Performing any required
programming before WINBIOS Setup next.
87h
The programming before WINBIOS Setup has
completed. Uncompressing the WINBIOS Setup code
and executing the AMIBIOS Setup or WINBIOS Setup
utility next.
88h
Returned from WINBIOS Setup and cleared the screen.
Performing any necessary programming after WINBIOS
Setup next.
89h
The programming after WINBIOS Setup has completed.
Displaying the power on screen message next.
8Bh
The first screen message has been displayed. The
<WAIT...> message is displayed. Performing the PS/2
mouse check and extended BIOS data area allocation
check next.
8Ch Programming the WINBIOS Setup options next.
8Dh
The WINBIOS Setup options are programmed.
Resetting the hard diskcontroller next.
8Fh
The hard disk controller has been reset. Configuring the
floppy drivecontroller next.
91h
The floppy drive controller has been configured.
Configuring the hard disk drive controller next.
95h
Initializing the bus option ROMs from C800 next. See
Table D-7 for additional information.
96h
Initializing before passing control to the adaptor ROM
at C800.
97h
Initialization before the C800 adaptor ROM gains
control has completed. The adaptor ROM check is next.