Filter
Top Products
Intermec EasyCoder F4 – Installation & Operation IPL Version, Ed. 334
Chapter 6
Setting Up the Printer
Description
The setup controls the printer in regard of serial communication,
test and service operations, and specifi es which types of media and
ribbon are loaded in the printer.
Check the list below to see if the printer’s default setup matches your
requirements. If not, you will have to change the setup. To enter the
Setup Mode, press the < Setup> key on the printer’s built-in keyboard
and follow the instructions in Chapter 7, “Setup Mode.”
The printer is, by default, set up according to the list below:
Communication
Baud rate: 9600 bps
Character length: 8 bits
Parity: None
Stop bits: 1 bit
Protocol: XON/XOFF
Test/Service
Testprint: n.a.
Data dump: No
Memory reset: n.a.
Label rest dots: 0
Form adj dots X: 0
Form adj dots Y: 0
Media
Media type: Gap
Paper type: DT
Label length: 1200 dots
Sensitivity: 420
Darkness: 0%
Default Setup