Filter
Top Products
Intermec EasyCoder F4 – Installation & Operation IPL Version, Ed. 362
Appendix 1
Printing
Print Technique Thermal Transfer and/or Direct Thermal
Printhead Resolution 8 dots/mm (203.2 dpi)
Print Speed (variable) 100 to 200 mm/sec. (≈ 4 to 8 inches/sec.)
Print Width (max) 104 mm (4.095 inches) = 832 dots
Print Length (max) 32767 dots = 409.5 cm(161.25 inches)
1
Media Width (min/max) 25 to 114.3 mm (1 to 4.5 inches) Standard edge guide
Media Width (min/max) 40/80 to 114.3 mm (1.57/3.15 to 4.5 inches) Quick-Load guides
Media Roll Diameter (max) 213 mm (8.38 inches) Short door/no takeup
Media Roll Core Diameter 38 to 40 mm (1.5 inches) or 76 mm (3 inches)
Ribbon Width (max) 110 mm (4.33 inches)
Ribbon Roll Diameter (outer) 62 mm (2.44 inches) ≈ 200 m (655 ft) ribbon
Ribbon Roll Core Diameter (inner) 25.4 mm (1.00 inches)
Print Directions 4
Modes of Operation
Tear-Off (Straight-through) Yes
Peel-Off (Self-strip) Optional With liner takeup unit
Firmware
Operating System Intermec IPL 3
Built-in fonts (std) 3 scaleable + 21 simulated bitmap fonts
Built-in bar code symbologies (std) 25
Physical Measures
Dimensions (W x L x H) 244 x 397 x 178 mm (9.61 x 15.63 x 7.00 inches) With long side door
Weight (excluding media) ≈ 7 kg (15.5 pounds) Depending on model
Ambient Operating Temperature +5°C to +40°C (+41°F to +104°F)
Humidity 20 to 80% non-condensing
Electronics
Microprocessor 32 bit RISC
On-board Flash SIMMs 2 sockets for 2 or 4MB each Std. 1 x 2MB
On-board DRAM SIMM 1 Std. 4MB
Power Supply
Mains Voltage >90 to <264 VAC, 45 to 65Hz
PFC Regulation IEC 61000-3-2
Maximum Power Consumption Continuous 140W; Peek 300W
Technical Data