Filter
Top Products
Intermec EasyCoder F4 – Installation & Operation IPL Version, Ed. 3 39
Chapter 6 Setting Up the Printer
Testprint, cont.
• UDC
The UDC Label tests the ability of the printer to receive and print
single or multiple user-defi ned characters (bitmap graphics) that
are sent from the host. Select between printing a single UDC or
labels for all the UDCs stored in the printer’s memory.
• Font
The Font Label contains all the characters in a single font. Select
between printing a single font or labels for all the fonts stored
in the printer’s memory. The latter uses a lot of media so it is
recommended to test one font at a time.
Data Dump
If data dump is enabled by selecting the “Yes” option, the printer
prints all data and protocol characters received on the serial port.
An ASCII and hexadecimal representation of each character is
printed.
Memory Reset
There are two options. The memory will be reset to factory default as
soon as an option has been selected and <Enter> is pressed. Select
between “All”, which resets the entire memory and “Confi guration”
which just resets the confi guration part of the memory.
Label Rest Dots
Specifi es where labels stop for removal. Use this for peel-off (self-strip)
applications. Allowed range is -30 (furthest back) to 30 (furthest
forward). Default is 0. Also available as an IPL command (<SI>fn).
Form Adj Dots X
Specifi es where the X-position of the origin should be placed on the
label. Allowed range is -30 (closest to the leading edge) to 30 (furthest
from the leading edge). Default is 0.
Form Adj Dots Y
Specifi es where the Y-position of the origin should be placed on the
label. Allowed range is -30 (closest to the center section) to 30 (furthest
from the center section). Default is 0.
Setup Parameters, cont.
Test/Service, cont.