JVC VN-E4 Network Card User Manual


 
28
Settings (continued)
A Operator Password The AoperatorB password is required to display current settings, or change current settings.
Enter the AoperatorB password and press the ASetB button.
The password is set to Avn-e4B in the factory settings. This can be changed on the APasswordB
page.
B CH1-CH4 Button Select a channel for setting.
C Display Screen For setting whether to mask each block upon dividing the screen into 12 x 12 blocks. In factory
settings, all blocks are masked.
The block turns blue when it is clicked, and it means unmasked. It returns to the normal state
upon clicking it again, and it means masked.
Press the ASendB button to validate current changes.
D Detection For setting motion detect to ON/OFF. To enable the setting, press the AMask AllB or ASendB
button.
E Sensitivity For setting the sensitivity of motion detect. To enable the setting, press the AMask AllB or ASendB
button.
F Motion For selecting the motion speed of the object for which motion is to be detected. To detect fast
motion, select AFastB. To detect slow motion, select ASlowB. To enable the setting, press the
AMask AllB or ASendB button.
G Mask All Button Masks all blocks and enables the currentADetectionB, ASensitivityB and AMotionB settings.
H Send Button For enabling the current AMaskB, ADetectionB, ASensitivityB and AMotionB settings.
NOTE:
The area display serves as a reference. Ensure to perform operation check.
Ensure that multiple blocks are used to set the size of the object for motion detect.
CAUTIONS:
When a camera is connected, flicker of fluorescent lights may cause malfunction during motion detect.
Changes in brightness due to auto iris or lighting may be detected as motion.
The motion detect feature is not intended to prevent theft or fire. This feature may not function properly depending on conditions
of the object and settings. Our company shall not be liable for any accident or damage that occurs.
A
D
E
F
G
H
B
C
The motion detect area will be displayed in blue.