Filter
Top Products
page 5.4
5. Maintenance Digital Projection LIGHTNING 35HD User Manual
To change the lamp:
• Press the LAMP button on the Main menu.
• Press LAMP OFF and hold for 3 seconds. The lamp will ramp down to minimum
and go off after a further 3 seconds.
• Allow the lamp to cool for 5 minutes.
• Push the main power switch downwards to switch off the power.
• Open the lamp compartment door.
• Unscrew each of the three lamp module screws until the thread disengages and
the knob can be pulled out a little against its spring pressure.
• Pull the lamp module out of the projector.
To fit the new lamp module:
• Rest the lamp module on the edge of the compartment and line up the white
nylon guides.
• Gently but firmly, push the lamp module in all the way until the connector
engages.
• Screw in each of the three lamp module screws until finger tight.
• Push the lamp compartment door closed.
Notes
Take care when removing the
lamp module, as it is heavy
(>10kg).
Take care not to touch the
glass surface of the lamp
module. If you do accidentally
touch the glass, it should be
cleaned before use.
Lamp module
screws