Filter
Top Products
AC In Connector
Connects the power cord attached to the unit.
50 or 60Hz Change Switch
Depending on the cycle of input power, turn to 50 for 50Hz and turn to
60 for 60Hz. .
Fuse
Use a fuse with a 2A AC250V rating.
AVL Type Input Connector
Connect to a dissolve controller such as the AVL DoveX2. Use
Ektagraphic type for a connector.
Dataton Type Input Connector
Use only when Datatons PAX is used as the dissolve controller. Connect
MDC200 with PAX by a cable that is supplied as an option.
Note: An AVL Type Input Connector and a Dataton Type Input Connec-
tor cannot be connected simultaneously to a dissolve controller.
OUT Connector
Connect to each dissolve connector (16P) of the 560DM/750DM Xenon
Slide Projectors.
HOME Connector
In the case that PAX is used, this connector is not used. Do not connect
anything. (Refer to Safety Precautions section.)
Navitar Dissolve Interface MDC200
36
Changing Connector
50/60 Hz.
HOME Connector
Dataton Type Imput Connector
OUT Connector
AC In Connector
Fuse
INL Type Imput Connector
CB
A
HOME
2
1
0
OUT
IN 2
IN 1
CB
A