Filter
Top Products
User’s Guide KODAK DP2000 Digital Projector
18
Turning Off the Projector
To completely turn off the projector, unplug it. If you want to turn the
projector back on immediately, you must allow about a minute for the
lamp to cool. The lamp won’t light if it’s too hot.
Note: Lamp life will be extended if you turn the lamp off, then wait
1 minute while the lamp cools before unplugging the
projector. The Lamp LED will light green when the lamp has
cooled. See page 24 for details on the Lamp LED.
If you want to turn off the display for a short period of time, press the
button on the keypad or remote. This blanks the screen for fifteen
minutes, but keeps the projector running. (You can change the amount
of time the projector stays in standby mode; see “Standby Time” on
page 31 for details.) After 15 minutes, the lamp goes out (the
projector keeps running). To exit standby mode, press the button
again. (It may take several seconds for the projection lamp to reach
full power and project the image again.)