Filter
Top Products
Operating the VP-128H Matrix Switcher
15
8 Operating the VP-128H Matrix Switcher
Operate your VP-128H via:
The front panel buttons
Remotely, from any one of up to 512 RC-1616 remote control panels via
10 Base T network and/or RS-232 serial commands transmitted by a touch
screen system, PC, or other serial controller
8.1 Switching OUT-IN Combinations
To switch an input to an output, do the following:
1. Press an OUTPUT SELECTOR
1
button
2
.
The button lights.
2. Press an INPUT SELECTOR
3
button
2
.
The button lights.
8.1.1 Operating in the AT ONCE Mode
The VP-128H only operates in the AT ONCE mode (that is, there is no
CONFIRM mode option) and pressing an OUT-IN combination implements
the switch immediately.
1 If the selected output is ‘locked’ the lamp in the output button flashes and the correct input status is tallied via the input
select button
2 This button operates in the ‘one out of n’ mode. When a button is pressed the previous button is cleared and the new
selection is latched and tallied
3 When an output is selected the current state of the corresponding input is tallied in the appropriate button. If the source is a
breakaway, a flashing lamp indicates the audio selection. If the output being controlled is locked, pressing the input select
button has no affect