Filter
Top Products
VP-81SIDN - Protocol 3000
43
13.1.4 Entering Commands
You can directly enter all commands using a terminal with ASCII communications
software, such as HyperTerminal, Hercules, etc. Connect the terminal to the serial
or Ethernet port on the Kramer device. To enter CR press the Enter key.
( LF is also sent but is ignored by command parser).
For commands sent from some non-Kramer controllers like Crestron, some
characters require special coding (such as, /X##). Refer to the controller manual.
13.1.5 Command Forms
Some commands have short name syntax in addition to long name syntax to allow
faster typing. The response is always in long syntax.
13.1.6 Chaining Commands
Multiple commands can be chained in the same string. Each command is
delimited by a pipe character (“|”). When chaining commands, enter the message
starting character and the message closing character only once, at the
beginning of the string and at the end.
Commands in the string do not execute until the closing character is entered.
A separate response is sent for every command in the chain.
13.1.7 Maximum String Length
64 characters
13.2 Kramer Protocol 3000 Commands
Command
Parameters
Description
#
Protocol handshaking
MODEL?
Read device model
VERSION?
Read device firmware version
SN?
Read device serial number
NAME?
Get device name
MACH-NUM
Set the machine num
BUILD-DATE?
Read device build date
PROT-VER?
Read device protocol version
HELP
List of commands
RESET
Reset device