Filter
Top Products
Basics
24
1
*4
Place the paper in the bypass tray, and specify the paper size. ⇒ p.63 “When copying
onto custom size paper”
When paper larger than 433mm is used, there are cases when the paper will be
jammed, creased, or not fed. Make sure the paper is placed correctly so that it is fed
straight.
*5
It is recommended to place one sheet at a time.
*6
The paper tray fence is fixed. If you wish to change the size of paper placed in this
tray, contact your service representative.
*7
When loading paper, make sure that the stack height does not exceed the lower limit
mark of the paper tray 2. ⇒ p.160 “Setting special paper in the Paper Tray 2”
*8
When the paper size is larger than A4
L
, you can load 10 sheets.
When the paper size is smaller than A4
L
, you can load 100 sheets.
*9
WhenthethickpapersizeislargerthanA4
L
, you can load 10 sheets.When the thick
paper size is smaller than A4
L
, you can load 40 sheets.
*10
When loading copy paper, make sure that the stack height does not exceed the limit
mark. The maximum number of sheets you can load at a time depends on the paper
thickness and condition.
*11
If you wish to copy onto thick (105g/m
2
, 28 lb or heavier) paper, select Thick Paper
mode. ⇒ "Special Paper Indication" in the System Settings manual
*12
Paper size up to 600mm(23.6") is available when an optional HDD is installed.
Important
❒ If you use damp or curled paper, staples may become jammed or a misfeed
may occur.
Note
❒ When loading copy paper in the paper tray 1-4 and the large capacity tray
(LCT), place the copy side of the paper face up.
❒ When loading copy paper in the bypass tray, place the copy side of the paper
face down.
❒ When you use the bypass tray, it is recommended to set the copy paper direc-
tion to
L
.
❒ Postcards and envelopes should be fed from the paper tray 2 or the bypass tray.
❒ Some kinds of envelopes might cause misfeeds and wrinkles. In this case, push
down the green lever of the fusing unit.
⇒
p.65 “When copying onto envelopes”
❒ Envelopes with large flaps should be fed from the paper tray 2 or a misfeed
might occur. See the illustration below.
2