Filter
Top Products
2: Installation
Ethernet LEDs
There are two LEDs located on the upper left and right corners of the Ethernet socket (see Figure
2-1). These indicate the status of the connection.
Left LED
Green ON, 100Mbps Ethernet Link
Green Blinking, 100Mbps Activity
Orange ON, 10Mbps Ethernet Link
Orange Blinking, 10Mbps Activity
OFF, No Ethernet Link
Right LED
Always OFF
The Ethernet port can connect to an Ethernet (10Mbps) or Fast Ethernet (100Mbps) network.
Status LED
The Status LED on the xPrintServer device is incorporated into the “X” letter of the Lantronix logo
on the top of the device. The behavior of this LED indicates the type of activity occurring in the
xPrintServer device. The Status LED color is orange when lit, and specific display patterns
indicate the specific type of activity. The LED may display a solid light, display no light, slowly
glow on, slowly glow off, or flash on/off.
Table 2-1 Status LED, Top of Device
Orange “X” LED
Description,
Solid
A continuous solid light indicates the power is on or the device is booting.
OFF
No light indicates the power is off.
Blinking
Even blinking pattern indicates the device is printing.
Glow / Dim
(Repeating Pattern)
Pulsating pattern of glowing and dimming light cycle occurring once every three
seconds. Indicates the device is booted, idle and waiting for a job.
Code 1
A repeating pattern of a single flash followed by two seconds
of no light indicates the device is obtaining the DHCP address.
Note: Codes 1
through 7 indicate
a grouped
number of flashes
in the Orange “X”
LED separated by
a two second
interval where the
light is off. The
specific
code/number of
flashes separated
by a two second
no-light interval
indicates a
specific status as
described in the
grey cells to the
left.
Code 2
A repeating pattern of two flashes followed by two seconds of
no light indicates there are no configured printers.
Code 3
A repeating pattern of three flashes followed by two seconds of
no light indicates a factory default reset.
Code 4
A repeating pattern of four flashes followed by two seconds of
no light indicates a successful firmware update.
Code 5
A repeating pattern of five flashes followed by two seconds of
no light indicates a failed firmware update.
Code 6
A repeating pattern of six flashes followed by two seconds of
no light indicates a printing error.
Code 7
A repeating pattern of seven flashes followed by two seconds
of no light indicates printer discovery is in process.
xPrintServer User Guide 10