Filter
Top Products
4: Configuration Using Web Manager
Server Configuration
Telnet Password Enter the password required for Telnet access.
Retype Password Re-enter the password required for Telnet access.
Advanced
ARP Cache Timeout
(secs)
When the unit communicates with another device on the
network, it adds an entry into its ARP table. ARP Cache
timeout defines the number of seconds (1-600) before it
refreshes this table.
TCP Keepalive (secs) TCP Keepalive time defines how many seconds the unit waits
during network failure or network interruption before checking
its status. If the unit does not receive a response, it drops that
connection. Enter a value between 0 and 65 seconds. 0
disables keepalive. The default setting is 45.
Monitor Mode @ Bootup
Select Disable to disable entry into the monitor mode using
the yyy or xx1 key sequence at startup. This field prevents the
unit from entering monitor mode by interpreting the stream of
characters that are received during the device server's
initialization at startup. The default setting is Enable.
CPU Performance Mode Select the UDS's performance mode. Higher performance
settings require more energy. Low is 26 Mhz. Regular is 48
Mhz; High is 88 Mhz. The default is Regular.
HTTP Server Port This option allows the configuration of the web server port
number. The valid range is 1-65535. The default HTTP server
port number is 80.
Config Server Port Not applicable for this product.
MTU Size The Maximum Transmission Unit (MTU) is the largest physical
packet size a network can transmit for TCP and UDP. Enter
between 512 and 1400 bytes. The default setting is 1400
bytes.
3. When you are finished, click the OK button.
4. On the main menu, click Apply Settings.
Host List Configuration
The UDS2100 scrolls through the host list until it connects to a device listed in the
host list table. After a successful connection, the unit stops trying to connect to any
others. If this connection fails, the unit continues to scroll through the table until the
next successful connection.
The host list supports a minimum of 1 and a maximum of 12 entries. Each entry
contains an IP address and a port number.
Note: The host list is disabled for Manual and Modem Mode. The unit does
not accept a data connection from a remote device when the hostlist option is
enabled.
To configure the host list:
1. On the main menu, click Hostlist.
UDS2100 User Guide 26