Filter
Top Products
6: Setup Mode: Server Configuration
DHCP Name
If a DHCP server has automatically assigned the IP address and network settings,
you can discover the unit by using the DeviceInstaller network search feature or
Monitor Mode (see
10: Monitor Mode).
Note: When you enter Monitor Mode from the serial port with network
connection enabled and issue the NC (Network Communication) command,
you see the unit’s IP configuration.
There are three methods for assigning DHCP names to the unit.
Default DHCP Name: If you do not change the DHCP name, and you are
using an IP of 0.0.0.0, then the DHCP name defaults to XX.XX.XX.XX
(XXXXXX is the last 6 digits of the MAC address shown on the label on the
bottom/side of the unit). For example, if the MAC address is 00-20-4A-12-34-
56, then the default DHCP name is C123456.
Custom DHCP Name: You can create your own DHCP name. If you are using
an IP address of 0.0.0.0, then the last option in Server configuration is Change
DHCP device name. This option allows you to change the DHCP name to an
alphanumeric name (LTX in our example).
Change DHCP device name (not set) ? (N) Y
Enter new DHCP device name : LTX
Numeric DHCP Name: You can change the DHCP name by specifying the last
octet of the IP address. When you use this method, the DHCP name is LTXYY
where YY is what you chose for the last octet of the IP address. If the IP
address you specify is 0.0.0.12, then the DHCP name is LTX12. This method
only works with 2 digit numbers (01-99).
UDS2100 User Guide 41