8: Setup Mode: Advanced Settings
Disable Port 77FE (Hex)
Note: If you choose to disable this option, keep in mind that disabling both
Telnet Setup and Port 77FE will prevent users from accessing the setup
menu from the network.
Port 77FE is a setting that allows DeviceInstaller, Web Manager, and custom
programs to configure the unit remotely. You may wish to disable this capability for
security purposes.
Disable Port 77FEh (N) ? _
The default setting is the N (No) option, which enables remote configuration. You can
configure the unit by using DeviceInstaller, web pages, Telnet, or serial configuration.
The Y (Yes) option disables remote configuration and web sites.
Disable Web Server
This setting defaults to the N (No) option. The Y (Yes) option disables the web
server.
Disable Web Server (N) ? _
Disable Web Setup
The Y (Yes) option disables configuration using the Web Manager. This setting
defaults to the N (No) option.
Disable Web Setup (N) ? _
Disable ECHO Ports
This setting controls whether port 7 echoes characters it receives. The default setting
is Y (Yes), which disables ECHO ports.
Disable ECHO ports (Y) ? _
Enable Enhanced Password
This setting defaults to the N (No) option, which allows you to set a 4-character
password that protects Setup Mode by means of Telnet and web pages. The Y (Yes)
option allows you to set an extended security password of 16-characters for
protecting Telnet and Web Page access.
Enable Enhanced Password (N) ? _
Default Settings (Option 7)
Select 7 to reset the unit’s Channel 1 configuration and expert settings to the default
settings. The server configuration settings for IP address, gateway IP address, and
netmask remain unchanged. The configurable pins’ settings also remain unchanged.
Following are the specific settings that this option changes:
UDS2100 User Guide 59