Filter
Top Products
3. If you are instructed to return the removed hard disk drive, follow all
packaging instructions and use any packaging materials that are supplied to
you for shipping.
4. To complete the removal procedure, go to “Completing the parts replacement”
on page 87.
Installing a hot-swap hard disk drive
Attention
Do not open your server or attempt any repair before reading and understanding the Safety
Information and the Warranty and Support Information on the ThinkServer Documentation DVD
that comes with your product, and “Guidelines” on page 37. To obtain a copy of the
publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to install a hot-swap hard disk drive.
This section applies only to server models that support hot-swap hard disk drives.
Attention: To maintain proper system cooling, do not operate the server for more
than 10 minutes without either a drive or a filler panel installed in each drive bay.
Important: Before you install optional hardware devices, make sure that the server
is working correctly. If the server is not working correctly, refer to theChapter 3,
“Diagnostics,” on page 13 for your server for detailed diagnostic information. To
obtain the publication, go to:
http://www.lenovo.com/support
To install a hot-swap hard disk drive, do the following:
Notes:
1. You do not have to turn off the server for the installation of a hot-swap hard
disk drive.
2. The cables come with the SATA hard disk drive option kit will not be used in
this server.
Chapter 5. Installing, removing, or replacing hardware 53