Filter
Top Products
Table 2. Numeric error codes (continued)
Symptom or error
FRU or action, in sequence
0191
System Security—Invalid Remote Change requested.
1. Run BIOS Setup Utility, and then save current
setting by pressing F10.
2. System board.
0192
System Security— Embedded Security hardware tamper
detected.
System board.
0193
RF antenna has been removed
Enter the supervisor password.
0194
The computer has been carried through a security gate
Enter the supervisor password.
0195
Security hardware tamper detected
1. Enter BIOS Setup Utility by entering supervisor
password, and select Password ➙ Security Chip
➙ Clear Security Chip to clear this error.
2. Security chip.
3. System board.
0196
Security hardware removed
1. Enter BIOS Setup Utility by entering supervisor
password, and select Password ➙ Security Chip
➙ Clear Security Chip to clear this error.
2. Security chip.
3. System board.
0197
Invalid remote change requested.
The remote conguration for the security chip has
failed. Conrm the operation and try again.
0199
System Security— Security password retry count
exceeded.
1. Run BIOS Setup Utility, and then save the current
setting by pressing F10.
2. System board.
01C8
Two or more modem devices are found. Remove all but
one of them. Press <Esc> to continue.
1. Remove either a Mini-PCI Card or a modem
daughter card. Otherwise, press Esc to ignore
the warning message.
2. System board.
01C9
Two or more Ethernet devices are found. Remove all but
one of them. Press <Esc> to continue.
1. Remove either a Mini PCI Ethernet card or an
Ethernet daughter card. Otherwise, press Esc to
ignore the warning message.
2. System board.
01C9
More than one Ethernet devices are found. Remove one
of them. Press <Esc> to continue.
1. Remove the Ethernet device that you installed; or
press Esc to ignore the warning message.
2. System board.
01CA
More than one Wireless LAN devices are found. Remove
one of them.
1. Remove the wireless LAN device that you
installed.
2. System board.
0200
Hard disk error—The hard disk is not working.
1. Reseat the hard disk drive.
2. Load Setup Defaults in BIOS Setup Utility.
3. Hard disk drive.
4. System board.
021x
Keyboard error.
Run interactive tests of the keyboard and the auxiliary
input device.
0220
Monitor type error—Monitor type does not match the one
specied in CMOS.
Load Setup Defaults in BIOS Setup Utility.
0230
Shadow RAM error—Shadow RAM fails at offset nnnn.
System board.
Chapter 4. Related service information 45