Filter
Top Products
Use To
Timeouts
Hibernate Timeout
Disabled
1 hour
2 hours
3 hours
6 hours
1 day
2 days
3 days
1 week
2 weeks
1 month
Set the printer to operate at a low power state.
Notes:
• When the Hibernate Timeout timer expires, the printer uses
Ethernet connection to check the value of “Hibernate
Timeout on Connection.”
• If “Hibernate Timeout on Connection” is set to “Do Not
Hibernate,” then the printer never automatically hibernates.
• If “Hibernate Timeout on Connection” is set to “Hibernate,”
then the printer follows the Hibernate Timeout value, except
when it is set to Disabled.
• Disabled is the factory default setting except for European
Union countries, Canada, and Switzerland.
• “3 days” is the factory default setting for European Union
countries, Canada, and Switzerland.
Timeouts
Screen Timeout
15–300 sec
Set the amount of time in seconds the printer waits before
returning the display to a ready state.
Note: “30 sec” is the factory default setting.
Timeouts
Prolong Screen Timeout
Off
On
Set the printer to continue the specified job without returning to
the home screen when the Screen Timeout timer expires.
Notes:
• Prolong Screen Timeout appears only in touch‑screen printer
models.
• On allows the user to reset the Screen Timeout timer instead
of returning to ready state.
• Off follows the normal Screen Timeout value.
• Off is the factory default setting.
Timeouts
Print Timeout
Disabled
1–255 sec
Set the amount of time in seconds the printer waits to receive an
end‑of‑job message before canceling the remainder of the print
job.
Notes:
• “90 sec” is the factory default setting.
• When the timer expires, any partially printed page still in the
printer is printed, and then the printer checks to see if any
new print jobs are waiting.
• Print Timeout is available only when using PCL emulation.
This setting has no effect on PostScript emulation print jobs.
Timeouts
Wait Timeout
Disabled
15–65535 sec
Set the amount of time in seconds the printer waits for additional
data before canceling a print job.
Notes:
• “40 sec” is the factory default setting.
• Wait Timeout is available only when the printer is using
PostScript emulation. This setting has no effect on PCL
emulation print jobs.
Understanding the printer menus 235