Filter
Top Products
Menu item Description
Print Area
Normal
Whole Page
Sets the logical and physical printable area
Notes:
• This menu does not appear if Edge to Edge is enabled in
the printer Setup menu.
• Normal is the factory default setting. When attempting to
print data in the non-printable area defined by the Normal
setting, the printer clips the image at the boundary.
• The Whole Page setting allows the image to be moved into
the non-printable area defined by the Normal setting, but
the printer will clip the image at the Normal setting
boundary.
• The Whole Page setting only affects pages printed using
a PCL 5e interpreter. This setting has no effect on pages
printed using the PCL XL or PostScript interpreter.
Download Target
RAM
Flash
Disk
Sets the storage location for downloads
Notes:
• RAM is the factory default setting.
• Storing downloads in flash memory or on a printer hard
disk places them in permanent storage. Downloads
remain in flash memory or on the printer hard disk even
when the printer is turned off.
• Storing downloads in RAM is temporary.
• This menu appears only if a flash and/or disk option is
installed.
Job Accounting
On
Off
Specifies whether the printer stores statistical information
about the most recent print jobs on the hard disk
Notes:
• Off is the factory default setting. Off means the printer
does not store job statistics.
• The statistics include a record of print errors, the print time,
the job size in bytes, the requested paper size and type,
the total number of printed pages, and the total number
of copies requested.
• Job Accounting is available only when a printer hard disk
is installed and working properly. It should not be
Read/Write or Write protected. Job Buffer Size should not
be set to 100%.
• Changing this setting from the printer control panel and
then exiting the menus causes the printer to reset. The
menu selection is updated.
Understanding printer menus
133