Filter
Top Products
206-4183
39
Transcoder Menu Commands
The following subsections describe how to access and use the Transcoder Menu commands.
Note: Refer to the Installation & Setup Guide for the applicable transcoder cards for further
information on transcoder configuration options.
Access the Transcoder Menu
1. Access the HCS6320 Main Menu as described on page 30.
2. At the
[Main] Command >
prompt, type card and press Enter.
3. At the
Enter card number (1-12) >
prompt, type the chassis slot number of the
transcoder card for which you wish to access configuration options. Then, press Enter.
The system identies the card type and then displays a command prompt for the card
menu, for example:
Card #1 is: HCS7720
[HCS7720 (1)] Command >
4. At the
Command >
prompt, either:
• Press Enter to display the card menu (see example below).
• Type the desired command and press Enter.
Note: You can always press Enter at the
Command >
prompt to display the Transcoder
Menu.
Example: Transcoder Menu
------------
HCS7720 Menu
------------
hwid Read Hardware ID
ver Read Software Versions
bits Read MUX Bitrates
pi Install PI Key
pr Reload PI Key
cksum Read PI Key Checksum
stb Satellite Receiver Menu
upd Update Firmware
irst Internal Reset
ret Return to Main Menu
[HCS7720 (1)] Command >
Conguration Options via Command Line (Cont.)