Filter
Top Products
206-4183
43
Satellite Receiver Menu Commands
The following subsections describe how to access and use the Satellite Receiver Menu
commands.
Access the Satellite Receiver Menu
1. Access the card menu for the selected transcoder (see “Access the Transcoder Menu” on
page 39).
2. At the
[HCS7720 (#)] Command >
prompt, type stb and press Enter.
3. At the
[Satellite (#)] Command >
prompt, either:
• Press Enter to display the Satellite Receiver Menu (see example below).
• Type the desired command and press Enter.
Note: You can always press Enter at the
Command >
prompt to display the Satellite
Receiver Menu.
Example: Satellite Receiver Menu
-----------------------
Satellite Receiver Menu
-----------------------
getch Read Current STB Channel
setch Set STB Channel
sglvl Read Satellite Signal Strength
lksts Read Satellite Lock Status
bnum Read STB Serial Number
cnum Read Smart Card Number
on Turn STB On
off Turn STB Off (Standby)
stbrst Reset Satellite STB
getupd Read STB Update Parameters
setupd Set STB Update Parameters
model Read STB Model
ver Read STB Software Version
ret Return to Card Menu
[Satellite (#)] Command >
Conguration Options via Command Line (Cont.)
where:
# is the chassis card/slot
number you selected for
conguration purposes.