Filter
Top Products
206-4183
45
Conguration Options via Command Line (Cont.)
Read the Satellite STB Serial Number
At the
[Satellite (#)] Command >
prompt, type bnum and press Enter to display the
satellite STB serial number, for example:
Card 1: STB serial# is: R0128005665-79
Read the Satellite STB Smart Card Number
At the
[Satellite (#)] Command >
prompt, type cnum and press Enter to display the
satellite STB smart card serial number, for example:
Card 1: Smart card# is: S1920968050-61
Power the Satellite STB On or Off
“Turn STB On” and “Turn STB Off” options in the Satellite Receiver Menu enable you to
power ON a satellite STB from standby mode or power OFF a satellite STB to standby mode.
At the
[Satellite (#)] Command >
prompt, either:
• Type on and press Enter to power ON the satellite STB.
• Type off and press Enter to switch the satellite STB to standby mode. HDMI ouput as well
as Ethernet streaming is disabled.
Reset the Satellite STB
1. At the
[Satellite (#)] Command >
prompt, type stbrst and press Enter to reset the
satellite STB.
2. At the
Reset (y/n)?
prompt, either:
• Type y and press Enter to reset the satellite STB. After reset, the satellite STB resumes
normal operation.
• Type n and press Enter to return to the
[Satellite (#)] Command >
prompt
without resetting the STB.
Read and/or Set STB Update Parameters
The STB Software Update feature enables the STB to check for and download software
updates on a one-time, user-dened basis. An STB update should periodically be scheduled
in conjunction with software updates from the satellite service provider.
Note: At the time an update is scheduled to begin, the STB will be switched to
standby in order to enable it to download the update. When the update window
is over, the STB will be powered back ON; however, note that it may take up to 10
minutes for streaming to resume. Contact your service provider for further
information.
You can view the current STB update status (scheduled, not scheduled, or in progress), and/
or you can modify the STB update status/parameters, as required.