Filter
Top Products
ConsoleServer 3200 System Lightwave Communications
Rev. A - 14 - www.lightwavecom.com
Four (4) 24-inch long CAT5 cables (PN 200.1061; straight-through, fully pinned) are used
between the Channel Extenders and the NETWORK / CONTROL card. One cable is used to
connect each of the Channel Extenders in Slots B through E to the corresponding port (see
below) on the new Network/Control Card.
If a Terminal Card remains in the 3230 system, that Channel Extender port of the Network /
Control Card is not used. Shown above, Network Slot E's Channel Extender position is
"unused"; and this unnecessary cable would not be installed in that position.
1.5.1 10/100 Port (Network)
The 10/100 BaseT Network connection is accessible on the bottom RJ45 connector on the
NETWORK / CONTROL card.
100-240V ~, 1A, 50/60 Hz
T 4A, 250 VAC
Caution! Replace with same type and rating fuse.
SWI TCH
B B B B B B B B
D D
C C
D D D D D D
C C CC C C
DEVI CE
A A
DE VICE
A A AA A A
DE VICE DEV ICE DEVICEDEVI CEDEVI CEDEVICE
B
D
C
EXTENDER EXTENDER
A
CHANNEL
TERMINAL
SWITCH
CHANNEL
MODEM
R
10/100
S
N
E
T
CONTROL
NETWORK/
E
D
E
N
X
T
E
N
N
E
L
H
A
C
E
R
M
T
CHANNEL
EXT ENDER