Filter
Top Products
ConsoleServer 3200 System Lightwave Communications
Rev. A - 82 - www.lightwavecom.com
When this prompt is displayed, the user is in monitor mode. There is no direct communication
between the user and the server. Any output from the server is saved to a buffer that may be
accessed by the user (see Section 7.11, Using the Buffer), but the user may issue no
commands to the server. If the user desires to issue commands to the server, they must enter
direct mode (see Section 7.10, Direct Mode).
Note that when selecting a server from a pull-down menu, only those device ports that are
installed shall be displayed.
8.9 Listening to a Server Session
F2 PULL-DOWN MENU TO LISTEN TO A DEVICE PORT PART 1
+--------------------------+
¦ LOGGED IN MENU ¦
+--------------------------¦
¦ CONNECT TO SERVER ¦
¦ DIR CONNECT TO SERVER ¦
¦ LISTEN TO SERVER ¦
¦ DISPLAY CONNECTED LIST ¦
¦ DISPLAY SERVER NAMES ¦
¦ DISPLAY ACTIVE DEVICES ¦
¦ LOGOUT ¦
¦ CHANGE PASSWORD ¦
¦ CHANGE DIRECT MODE ESC ¦
¦ CHANGE BREAK MODE ESC ¦
¦ DISPLAY HELP ¦
+--------------------------+