Filter
Top Products
A Lantronix Company SCS3230 System Administrator's Guide
15.00.038 - 29 - May 2002
5.4 Device Card
NOTE: DEVICE Cards MUST be updated to Version 4.03 (or higher) firmware for SCS3230
The SCS3230 is designed so that the default device port communications settings will match
the communications settings of most Sun® server and workstation console ports (9600 baud, 8
data bits, no parity, one stop bit). Other equipment types (i.e., Cisco®) frequently use similar
communications settings; check the manuals included with the equipment for the correct
settings. The table below lists the default serial port communications settings for the SCS3230.
Sections 6.3 and 6.4 outline the commands for changing the terminal and device port
communications settings.
The following tables list the adapter part number and port configuration for some common
equipment types that may be connected to the SCS3230. Note that in some cases, an
additional cable or adapter is included with the equipment to convert a proprietary pinout to an
EIA-standard pinout. Also, note that it is not possible to connect the RJ45 serial port of the
ConsoleServer directly to the RJ45 serial port of any third-party equipment. Sun Netra
servers, Cisco switches, and other similar devices require a special adapter or cable to connect
to the ConsoleServer. The adapter or cable is usually provided by the manufacturer of the
equipment (e.g., Sun), or may need to be created by the user. The adapters and cables from
the equipment manufacturer are usually designed to interface directly to a terminal, so the
ConsoleServer device port must be configured as DTE rather than its default value of DCE.
Lightwave Communications has pre-made adapters and kits for some common equipment
types; contact Lightwave for information regarding your specific application.
Note: Some adapters are also available in quantity packs, and may be shipped under a different
part number. Quantity packs are "299.xxxx" compared to "200.xxxx".
Device Card typical adapters and 3200 port configuration:
System Type Adapter Part Number Port Configuration
SUN 200.0066 DCE
HP, SGI, PC (9pin) 200.0070 DCE
PC (25pin) 200.0067 DCE
Sun Netra t1/Cisco 200.0225 DCE
RJ45 to RJ45 Cables:
Part Number Length
200.0062 2m
200.0063 5m
200.0064 10m
200.0065 15m