Filter
Top Products
ConsoleServer 3200 System Lightwave Communications
Rev. A - 70 - www.lightwavecom.com
• The unique hardware (MAC) address of the card, expressed as six groups of one-byte
hexadecimal numbers
• IP source 3200, BootP, RARP
• The primary IP information, including: IP address, subnet mask, and gateway
• The secondary IP information, including: destination address, subnet mask, and gateway
The terminal and device cards will return the following information:
• The terminal or device port number
• The port letter as indicated on card label
• Equipment port type (DCE or DTE)
• Baud rate
• Parity; N=none, E=even, O=odd
• Data bits
• Stop bits
• Flow control type
• Status of RTS line; 0=off, 1=on
• Status of DTR line; 0=off, 1=on
The labels “RTS” and “DTR” do not change when the port type is changed from DCE to DTE.
When the port type is changed, the label “RTS” indicates the status of the CTS line, and “DTR”
indicates the status of the DSR line.
7.9.5 POWERSTATUS Command
sys admin>>powerstatus
Power supply A is OK
Power supply B is OK
sys admin>>
The POWERSTATUS command displays the status of the two redundant power supplies in the
SCS3230 chassis. Power supplies will either be listed as OK or Failed. The SCS3230 will
continue to function with one failed power supply. Contact Lightwave for information regarding
replacement if a power supply fails.
7.9.6 LOG Command
sys admin>>log /enable
The SCS3230 can report current system activity through control card port B. The report is
enable using the command LOG /ENABLE, and disabled using the command LOG /DISABLE.
The system will report user logins, logouts, device port selections, and entry/exit from direct
mode. Note that there is no system clock on the SCS3230, so there is no time/date stamp on
system activity. If a time/date stamp is required, it must be provided by the system capturing
the data output.