Filter
Top Products
10/100 Network In a Box
19
Linksys EtherFast
®
Series
18
Installing the Driver in Windows 95 Version B
1. While the Update Device Driver Wizard window is visible (previous page),
put the EtherFast Card 10/100 LAN Card Driver Disk into your floppy
drive and click Next.
2. Windows 95 will find the Linksys LNE100TX Fast Ethernet Adapter
(LNE100TX v4) driver on the disk. If Windows fails to find the driver, see
problem 2 on page 44. Click Finish.
3. Windows will begin copying the EtherFast Card’s driver files to your PC.
Refer to the chart on the next page to help guide you through the process.
Windows 95 Installation & Setup
Overview
After installing the EtherFast hardware in your computer, follow these
instructions for installing the network driver. The installation procedure for
the network driver will vary slightly depending on the version of Windows 95
you are using and your current system configuration. For troubleshooting tips
during setup, refer to page 44.
There are different versions of Windows 95:
• Version A
• Version B (also known as OSR2)
The installation procedure for the network
driver will vary slightly depending on which
version of Windows 95 you are using. To
begin the driver installation, and to determine
which version of Windows 95 you are using:
1. If you already haven’t, start up your PC.
2. Windows 95 will automatically detect the
EtherFast Card in your computer. If an Update Device Driver Wizard win-
dow (below, or another similar window) appears, you are using Windows
95 version B. If not, you are using version A. Skip to page 51.
I
NNoottee::
During the installation,
Windows 95 may ask you for a
ccoommppuutteerr oorr wwoorrkkggrroouupp nnaammee
. If
so, skip ahead to the instructions
on page 23. Once you have
established your computer and
workgroup names, go back to
where you left off and continue
with the installation.