Filter
Top Products
10/100 Network In a Box
35
Linksys EtherFast
®
Series
34
13. Click Finish. When asked if you want to restart your computer, remove
the Driver Disk and click Ye s .
14. Once your PC has rebooted and you are logged in, double-click the
Network Neighborhood icon on your desktop. Ensure that you have
access to the network. If you do, your card has been properly installed.
• If you had previously installed any NT service packs, you must go back
and re-install those service packs now.
• If you need to install the TCP/IP protocol, refer to your system adminis-
trator or your Windows NT documentation. Linksys does not provide
technical support for the configuration or troubleshooting of the TCP/IP
protocol
The Windows NT Installation and Setup of the EtherFast 10/100 LAN
Card is complete. Do not continue on with the next set of instructions.
They are for NT users who already had their networking configured.
NNoottee
: If you had previously installed any NT service
packs, you must re-install them. Otherwise, you may
receive Not Enough Service Storage Space errors in
the Event Viewer.
11. NT will copy the necessary network
drivers to your PC. When the copying is
complete, you will see a list of installed
bindings. Change the bindings settings if
needed and click Next. Click Next
again.
12. Choose either Workgroup or Domain, depending on the type of network
you're setting up. (Your Microsoft documentation explains the difference
between Workgroups and Domains.) Click Next.
NNoottee::
For information and help on
choosing your bindings, services
and protocols, ask your network
administrator, or check your
Windows NT documentation.