Filter
Top Products
10/100 Network In a Box
10. Remove your Driver Disk and CD-ROM and click Ye s to restart your PC.
11. Once your PC has rebooted, double-click the Network Neighborhood
icon on your desktop. Ensure that you have access to the network. If you
do, your card has been properly installed.
• If you had previously installed any NT service packs, you must re-install
them. Otherwise, you may receive Not Enough Service Storage Space
errors in the Event Viewer.
• If you need to install the TCP/IP protocol, refer to your system adminis-
trator or your Windows NT documentation. Linksys does not provide
technical support for the configuration or troubleshooting of the TCP/IP
protocol
The Windows NT Installation and Setup of the EtherFast 10/100 LAN
Card is complete.
39
Linksys EtherFast
®
Series
38
NNoottee
: If you had previously installed any NT service packs, you
must re-install them. Otherwise, you may receive Not Enough
Service Storage Space errors in the Event Viewer.
6. When NT asks you for the media type. Choose the AutoSense option.
When finished, click on OK. Click Close.
7. NT will probably ask you to
supply your original Windows
NT CD-ROM or setup disks.
Direct Windows NT to the
proper location (most likely
D:\i386).
8. Click on the Protocols tab. Add any protocols you require by clicking the
Add button. (Refer to your Microsoft documentation if you have any ques-
tions on adding protocols.)
9. After your bindings, settings, and services are set, click the Close button.
NNoottee::
If you install the
TTCCPP//IIPP pprroottooccooll
, refer to
your system administrator or your Windows NT
documentation when installation steps that aren’t
listed in this User Guide appear. Linksys does
not provide technical support for the configura-
tion or troubleshooting of the TCP/IP protocol.