Filter
Top Products
43
Wireless-G PrintServer
Chapter 7: Bi-Admin Management
The Bi-Admin Management Utility
• Upgrade. You may use this option to upgrade the firmware of the PrintServer. Follow these instructions:
1. On the Upgrade screen, click the Files button.
2. The Detected LAN Cards screen will appear. Select the LAN card the PrintServer is connected to, and then
click the OK button.
3. Follow the on-screen instructions, and select the firmware file you want to use.
4. View the BIN File Information screen, and click the OK button if you have selected the correct firmware
file. Click the Cancel button to select a different firmware file.
5. On the Upgrade screen, click the Upgrade button. Click the Cancel button to cancel the firmware
upgrade. For more information, click the Help button.
• Refresh. This option allows you to refresh the device list after you change the name or IP address of a device.
The screen does not refresh automatically.
• Exit. This option allows you to exit the Bi-Admin program.
InitDevice. The available options are Reset Device, Restore to Factory Default, Attached Remote, and Connected
Protocol.
If you click Attached Remote, the Add Cross Segment Printer screen appears. To add a cross segment print
server, enter its IP address in the fields provided, and click the Set button.
Click Cancel to undo any changes. For more information, click the Help button.
Diagnostic. Diagnostic allows you to print a test page from either of the PrintServer’s ports.
Help. The two options are Help Topics and About Bi-Admin. These help files offer extensive advice and details
about all of the PrintServer’s functions and capabilities.
Figure 7-19: Detected LAN Cards
Figure 7-20: BIN File Information
Figure 7-21: Add Cross Segment PrintServer
Figure 7-18: Upgrade