Filter
Top Products
SFE2010/SFE2010P Administration Guide 32
System Configuration
Using the Console
1. IPv6 Interface Enable (see page 32)
2. IPv6 Address Settings (see page 33)
3. IPv6 Address Table (see page 34)
4. IPv6 ISATAP Enable (see page 34)
5. IPv6 ISATAP Interface Show (see page 35)
6. IPv6 Default Gateway (see page 36)
To open this screen:
1. From the S
w
itch Main Menu, select 1. System Configuration.
2. From the Sy
stem Configuration Menu, select 6. IP Configuration.
3. From the IP
Configuration menu, select 2. IPv6 Address Configuration.
IPv6 Interface Enable
You can use the IPv6 Int
erface Enable screen to enable or disable the IPv6 interface.
To open this screen:
1. On the Sw
itch Main Menu, select 6. IP Configuration.
2. On the IP Configuration menu, selec
t 2. IPv6 Address Configuration.
3. On the IPv6 Address Configuration me
nu, select 1. IPv6 Interface Enable.
To edit the IPv6 interface settings:
1. When you finish using this Select Ed
i
t., and then make the changes. Press the Tab key to
move the cursor from one field to the next.
NOTE: To enable or disable the interface, move the cursor to the field, and then press the
Sp
ace Bar to toggle between ENABLE and DISABLE. If you select ENABLE, a warning
appears. Press the Enter key to acknowledge the warning.
2. Press the Es
c ke
y to move the cursor to the Action list.