Filter
Top Products
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
This symbol warms the user that uninsulated voltage
within the unit may have sufficient magnitude to cause
electric shock. Therefore, it is dangerous to make any
kind of contact with any part inside of this unit.
This symbol alerts the user that important literature
concerning the operation and maintenance of this unit
has been included. Therefore, it should be read
carefully in order to avoid any problems.
WARNING
TO PREVENT FIRE OR SHOCK HAZARDS.
DO NOT EXPOSE THIS UNIT TO RAIN OR
MOISTURE. ALSO DO NOT USE THIS UNIT’S
POLARIZED PLUG WITH AN EXTENSION
CORD RECEPTACLE OR OTHER OUTLETS,
UNLESS THE PRONGS CAN BE FULLY
INSERTED. REFRAIN FROM OPERATING
THE CABINET AS THERE ARE HIGH-
VOLTAGE COMPONENTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PERSONNEL.
DOC compliance Notice
This class A digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.
WARNING
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in according with the instruction manual,
may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to
correct the interference in which case the user will be required to
correct the interference at his own expense.
PRECAUTIONS
Please read this manual carefully before using your marantz 42 inch
Plasma Monitor and keep the manual handy for future reference.
IMPORTANT INFORMATION
Warnings and Safety Precaution
The SLIM SERIES PLASMA MONITOR PD4292D is designed
and manufactured to provide long, trouble-free service. No
maintenance other than cleaning is required. Use a soft dry cloth
to clean the panel. Never use solvents such as alcohol or thinner
to clean the panel surface.
For operating safety and to avoid damage to the unit, read
carefully and observe the following instructions.
To avoid shock and fire hazards:
1. Provide adequate space for ventilation to avoid internal heat
build-up. Do not cover rear vents or install in a closed cabinet
or shelves.
The unit is equipped with cooling fans. If you enclose the unit
in a cabinet or rack, be sure there is adequate space at the
top of the unit to allow heated air to rise and escape.
If the monitor because too hot, the overheat protector will be
activated and the monitor will be turned off. If this happens,
turn off the power to the monitor and unplug the power cord.
If the room where the monitor is installed is particularly hot,
move the monitor to a cooler location, and wait for the
monitor to cool for 60 minutes. If the problem persists,
contact your marantz dealer for service.
2. Do not use the power cord polarized plug with extension
cords or outlets unless the prongs can be completely
inserted.
3. Do not expose unit to rain or moisture.
4. Avoid damage to the power cord, and do not attempt to
modify the power cord.
5. Unplug unit during electrical storms of if unit will not be used
over a long period.
6. Do not open the cabinet which has potentially dangerous
high voltage components inside. If the unit is damaged in this
way the warranty will be void. Moreover, there is a serious
risk of electric shock.
7. Do not attempt to service or repair the unit. marantz is not
liable for any bodily harm or damage caused if unqualified
persons attempt service or open the back cover. Refer all
service to authorized marantz Service Centers.
To avoid damage and prolong operating life:
1. Use only with 120 V 50/60 Hz AC power supply. Continued
operation at line voltage greater than 120 Volts AC will
shorten the life of the unit, and might even cause a fire
hazard.
2. Handle the unit carefully when installing it and do not drop.
3. Locate set away from heat, excessive dust, and direct
sunlight.
4. Protect the inside of the unit from liquids and small metal
objects. In case of accident, unplug the unit and have it
serviced by an authorized marantz Service Center.
5. Do not hit or scratch the panel surface as this cause flaws on
the surface of the screen.
6. For correct installation and mounting it is strongly
recommended to use a trained,authorized Marantz dealer.
7. As is the case with any phosphor-based display (like a CRT
monitor, for example) light output will gradually decrease over
the life of a Plasma Display Panel.
PD4292D-1 00.10.4, 3:08 PM2