Filter
Top Products
Extended AT Commands Manual Page 25 of 70 2009-06-25
Command TE2
Æ
MT2 $$RINGIDX=<value>
Response TE2
Å
MT2 <result_code> (OK | ERROR)
5.5. Network Relational Settings
5.5.1.1. Roaming indicator information (AT$$ROAMIND)
This command is used for reading Roaming Indicator Information.
Table 5-38 Read command
Command TE2
Æ
MT2 $$ROAMIND
Response TE2
Å
MT2 $$ROAMIND: <value>
Value
0: Not Roaming
1: Roaming inside preferred roaming list
2: Roaming outside preferred roaming list
5.5.1.2. Antenna Signal Level report schedule (AT$$ANTSET)
The command is used for reading or setting the notification period of $$ANTLVL notification in
seconds. If no changes are monitored $$ANTLVL does not report to $$ANTSET values.
Table 5-39 Read command
Command TE2
Æ
MT2 $$ANTSET?
Response TE2
Å
MT2 $$ANTSET: <value>
Value
0: Read once
1~43200: Notification every <x> seconds
Table 5-40 Set command
Command TE2
Æ
MT2 $$ANTSET=<value>
Response TE2
Å
MT2 <result_code> (OK | ERROR)
5.5.1.3. Antenna Signal Level (AT$$ANTLVL)
The antenna level range is 0 (no service) to 7 (strong signal). If no changes are monitored
$$ANTLVL does not report to $$ANTSET values.
Table 5-41 Notification command
Notify TE2
Å
MT2 $$ANTLVL: <value>
Value 0-7: 0 (no service) to 7 (strong signal)
If MT2 doesn’t receive a response (ACK) against ANTLVL, MT2 notifies two more times at the set
interval irrespective to any changes to the level.