Metrologic Instruments MS7600 Scanner User Manual


 
10
Figure 7: USB, Interface
INSTALLATION FOR USB INTERFACE
1. Turn off the host system.
2. Connect the PowerLink USB cable to
the 2
nd
jack down from the top of the
MS7600.
3. Connect the other end of the USB
cable to the host.
Before continuing verify that the
USB PowerLink cable is connected to
the appropriate interface jack on the
scanner. An incorrect cable
connection can cause communication
problems or potential damage to the
scanner.
Manufacturers Note:
Plugging the scanner into the serial
port of the PC does not guarantee
that scanned information will appear
at the PC. A software driver and
correct configuration setting are also
required for proper communication to
occur.
4. Scan the Enable USB Defaults bar
code to configure the MS7600 for
USB communication.
5. Turn on the host system.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must meet the requirements
for SELV (Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No. 60950-00/UL 60950 and norm EN 60950, the power source
should meet applicable performance requirements for a limited power source.
³999978
Enable USB Defaults