Metrologic Instruments MS7600 Scanner User Manual


 
13
Figure 9: RS232/IBM, Interface
INSTALLATION FOR IBM 46XX INTERFACE
1. Turn off the host system.
2. Connect the MVC cable to the
1
st
jack down from the top of
the MS7600.
3. Connect the other end of the MVC
cable to the host.
Before continuing verify that the MVC
cable is connected to the appropriate
interface jack on the scanner. An
incorrect cable connection can cause
communication problems or potential
damage to the scanner.
Manufacturers Note:
Plugging the scanner into the serial
port of the PC does not guarantee
that scanned information will appear
at the PC. A software driver and
correct configuration setting are also
required for proper communication to
occur.
4. Turn on the host system.
5. Scan the Load 46xx IBM Defaults bar
code to configure the MS7600 for IBM
46xx communication.
For additional communication options for IBM interfaces refer to the MetroSelect
Programming Guide (
MLPN 00-02407A-1 & -2).
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must meet the requirements
for SELV (Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No. 60950-00/UL 60950 and norm EN 60950, the power source
should meet applicable performance requirements for a limited power source.
³999995
Load 46xx IBM Defaults