Metrologic Instruments MS7600 Scanner User Manual


 
11
Figure 8: RS232 or
Light Pen Interface
INSTALLATION FOR RS232 OR LIGHT PEN INTERFACES
1. Turn off the host system.
2. Connect the PowerLink cable into
the 1
st
jack down from the top of the
MS7600.
3. Connect the other end of the
PowerLink cable to the host.
Before continuing verify that the
PowerLink cable is connected to the
appropriate interface jack on the
scanner. An incorrect cable
connection can cause
communication problems or potential
damage to the scanner.
4. Connect the external power supply
to the power jack on the Power Link
Cable.
5. Check the AC input requirements of
the power supply to make sure the
voltage matches the AC outlet.
6. Connect AC power to the
transformer. The outlet should be
near the equipment and easily
accessible.
7. Scan the appropriate bar codes
on page 12 to configure the MS7600
for RS-232 or Light Pen
communication.
8. Turn on the host system.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must meet the requirements
for SELV (Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No. 60950-00/UL 60950 and norm EN 60950, the power source
should meet applicable performance requirements for a limited power source.