Filter
Top Products
Installation and User Manual
CAUTION
Isolate and lock-out all power sources for this card before
making connections. Never connect ELSV (extra low safety
voltage) and non-ELSV circuits to the different outputs of the
same card.
2.4 Removing the Cover
1. Remove the cover “3” secured by the screws “1”.
2. Run the communications cables through the cable entry holes “4”.
3. Connect the conductors to the input “6” and output “5” terminal blocks (see connection example in diagram
below).
Figure 2-2: Remove Cover Diagram.
2.4.1 Replacing the Cover
1. Put the cover back in place and secure it with the screws “1”.
2. Tighten the screws “7” to block the cables.
3. Indicate the locations of the power sources on the labels.
4. Insert the card in its slot.
5. Secure the card with two screws “1”, “2”.
Installation 2 — 5
86-172010-00 C05
1
2
3
4
5
6
A
B
1
2
3
2
5
7
6
4
1
2
2
7
1
2
3
4
5
6
A
B
4
3
5
6
Remove Cover
Replace Cover