Filter
Top Products
IP Routing
3-235
3
• OSPFv2 is a compatible upgrade to OSPF. It involves enhancements to protocol
message authentication, and the addition of a point-to-multipoint interface which
allows OSPF to run over non-broadcast networks, as well as support for
overlapping area ranges.
• When using OSPF, you must organize your network (i.e., autonomous system) into
normal, stub, or not-so-stubby areas; configure the ranges of subnet addresses
that can be aggregated by link state advertisements; and configure virtual links for
areas that do not have direct physical access to the OSFP backbone.
- To implement OSPF for a large network, you must first organize the network into
logical areas to limit the number of OSPF routers that actively exchange Link
State Advertisements (LSAs). You can then define an OSPF interface by
assigning an IP interface configured on this router to one of these areas. This
OSPF interface will send and receive OSPF traffic to neighboring OSPF routers.
- You can further optimize the exchange of OSPF traffic by specifying an area
range that covers a large number of subnetwork addresses. This is an important
technique for limiting the amount of traffic exchanged between Area Border
Routers (ABRs).
- And finally, you must specify a virtual link to any OSPF area that is not physically
attached to the OSPF backbone. Virtual links can also be used to provide a
redundant link between contiguous areas to prevent areas from being
partitioned, or to merge backbone areas.
Configuring General Protocol Settings
To implement dynamic OSPF routing, first assign VLAN groups to each IP subnet to
which this router will be attached, then use the OSPF / General Configuration menu
to enable OSPF, assign an Router ID to this device, and set the other basic protocol
parameters.
Command Attributes
General Information –
• OSPF Routing Process – Enables or disables OSPF routing for all IP interfaces
on the router. (Default: Disabled)
• OSPF Router ID – Assigns a unique router ID for this device within the
autonomous system. (Default: The lowest interface address)
• Version Number
23
– This router only supports OSPF Version 2.
• Area Border Router
23
– Indicates if this
router connect directly to networks in two
or more areas. An area border router runs
a separate copy of the Shortest Path First
algorithm, maintaining a separate routing
database for each area.
23. These items are read only.
backbone
area,
stub,
NSSA
ABR