Filter
Top Products
IP Interface Commands
4-241
4
IP Interface Commands
There are no IP addresses assigned to this router by default. You must manually
configure a new address to manage the router over your network or to connect the
router to existing IP subnets. You may also need to a establish a default gateway
between this device and management stations or other devices that exist on another
network segment (if routing is not enabled).
This section includes commands for configuring IP interfaces, the Address
Resolution Protocol (ARP) and Proxy ARP. These commands are used to connect
subnetworks to the enterprise network.
Basic IP Configuration
Uptime The time elapsed since this entry was created.
Expire The time remaining before this entry will be aged out. (The default is 260 seconds.)
V1Timer The time remaining until the switch assumes that there are no longer any IGMP Version
1 members on the IP subnet attached to this interface. (The default is 400 seconds.)
Table 4-79 IP Interface Commands
Command Group Function Page
Basic IP Configuration Configures the IP address for interfaces and the gateway router 4-241
Address Resolution
Protocol (ARP)
Configures static, dynamic and proxy ARP service 4-246
Table 4-80 Basic IP Configuration Commands
Command Function Mode Page
ip address Sets the IP address for the current interface IC 4-242
ip default-gateway Defines the default gateway through which this router can reach
other subnetworks
GC 4-243
show ip interface Displays the IP settings for this device PE 4-244
show ip redirects Displays the default gateway configured for this device PE 4-244
ping Sends ICMP echo request packets to another node on the
network
NE,
PE
4-245
Table 4-78 show ip igmp groups - display description (Continued)
Field Description