Filter
Top Products
System Management Commands
4-49
4
show log
This command displays the log messages stored in local memory.
Syntax
show log {flash | ram}
• flash - Event history stored in flash memory (i.e., permanent memory).
• ram - Event history stored in temporary RAM (i.e., memory flushed on
power reset).
Default Setting
None
Command Mode
Privileged Exec
Example
The following example shows the event message stored in RAM.
SMTP Alert Commands
These commands configure SMTP event handling, and forwarding of alert
messages to the specified SMTP servers and email recipients.
Console#show log ram
[1] 00:01:30 2001-01-01
"VLAN 1 link-up notification."
level: 6, module: 5, function: 1, and event no.: 1
[0] 00:01:30 2001-01-01
"Unit 1, Port 1 link-up notification."
level: 6, module: 5, function: 1, and event no.: 1
Console#
Table 4-21 SMTP Alert Commands
Command Function Mode Page
logging sendmail host SMTP servers to receive alert messages GC 4-50
logging sendmail level Severity threshold used to trigger alert messages GC 4-50
logging sendmail
source-email
Email address used for “From” field of alert messages GC 4-51
logging sendmail
destination-email
Email recipients of alert messages GC 4-51
logging sendmail Enables SMTP event handling GC 4-52
show logging sendmail Displays SMTP event handler settings NE, PE 4-52