Filter
Top Products
Replacing Parts and Supplies
7
CF2002/CF3102 7-11
7.3 Empty the Hole Punch Waste Container
If the punch kit is installed in the finisher FN-8, the message “Remove
Punch Scraps” will appear when the hole-punch waste container is full.
To empty the hole-punch waste container
Empty the hole-punch waste container, and then re-install it according to
the following procedure.
1 Slide the finisher away from the
copier.
2 Pull out the hole-punch waste
container.
3 Empty the container.
4 Insert the hole-punch waste
container into its original position.
5 Slide the finisher back against the
copier.
CF2002.book Page 11 Friday, June 13, 2003 9:29 AM