Filter
Top Products
Troubleshooting
8
CF2002/CF3102 8-27
Replace Staple Cartridge X. The staples have run out. Replace the staple cartridge.
(p. 7-6)
Re-insert the following# of
originals:
After clearing a paper
misfeed, it is necessary to
reload the documents that
have already been fed
through the document
feeder.
Load the indicated document
pages into the document
feeder.
Malfunction detected.
Call your Technical Rep. and
provide code:
The copier malfunctioned
and is unable to make
copies.
Inform your technical
representative of the code
displayed on the touch
panel.
Replace the CF toner
cartidge. Open the front door
and follow the instructions.
Toner is empty. Copies can
no longer be made.
Replace the toner cartridge
according to your
maintenance agreement
(p. 7-1).
Misfeed detected A flashing “O” indicates the
location of a paper misfeed.
Determine the misfeed
location by looking at the
illustration displayed with the
error message, and then
clear the misfeed (p. 8-1).
Staple Mode cannot be used Staples are jammed in
Finisher FN-116 or FN-8.
Clear the jammed staples
(p. 8-17).
Remove Punch Scraps Hole-Punch waste container
is full.
Empty the hole punch waste
container (p. 7-11).
(Inspection Mark in
the lower left side of the
basic screen)
The image stabilization or
printing or scanning
functions of the copier have
become unstable.
Touch the inspection mark in
order to show the Machine
Status screen. Contact your
technical representative and
inform them of the numbers
(e.g. “P-7”) shown in the
Machine status screen.
XXXX needs to be replaced
soon.
It is almost time to replace
supplies or a part. About
1,000 copies can be made
with the old supplies or part
before the copier stops
operating.
Prepare the new supplies or
part.
Please have the XXXX
changed soon.
Message Cause Remedy
CF2002.book Page 27 Friday, June 13, 2003 9:29 AM