Filter
Top Products
Precautions
2
CF2002/CF3102 2-7
2.2 Installation Requirements
Power Source
The power source requirements are as follows.
● Voltage fluctuation: Maximum 230 V ±10%
● Frequency fluctuation: Maximum ±0.3%
❍ Use a power source with as little voltage or frequency fluctuations as
possible.
Installation Site
To ensure utmost safety and prevent possible malfunctions, install the
copier in a location that meets the following requirements.
- A location away from curtains, etc. that may catch fire and burn easily
- A location that is not exposed to water or other liquids
- A location free from direct sunlight
- A location out of the direct airflow of an air conditioner or heater, and
not exposed to extremely high or low temperatures
- A well-ventilated location
- A location that is not exposed to high humidity
- A location that is not extremely dusty
- A location not subjected to undue vibrations
- A stable and level location
- A location where ammonia or other organic gases are not generated
- A location that does not put the operator in the direct airflow of exhaust
from the copier
- A location that is not near any kind of heating devices
CF2002.book Page 7 Friday, June 13, 2003 9:29 AM