Filter
Top Products
Part identification and functions
2-4
Overview
Chapter 2
11.
SCSI connector:
Connect the SCSI cable included in the interface kit.
When multiple SCSI devices are connected to the
personal computer, connect the Scanner at the end of the
SCSI chain. (Optional PC interface kit is required)
The total length of the SCSI cables must be 6 m or less
when used for daisy-chaining all the SCSI units alone or
3 m or less when used for daisy-chaining all the SCSI
units and SCSI-2 units.
12.
Foot switch connector:
Connect the foot switch (option) cable to this connector.
Use the left terminal (viewed from the rear) to read the
right page when the foot switch is pressed, and the right
terminal for the left page. Either terminal can be used
when reading two spread pages.
13.
Power cord socket:
Plug the power cord into this socket.
14.
Power cord:
Connects the Scanner to the power outlet.
15.
Foot switch (option):
Press this switch instead of the start key on the book
table to start scanning. Used when a large original is
covering the start key.
16.
Counter:
Counts the number of originals scanned.
17.
Angle book holder (option):
Used to scan the original whose spine (binding part)
should not be damaged (e.g., precious book).
18.
Stopper:
Used as the reference position for the original. When
placing the original, align its top edge with this position.
19.
Center mark:
Adjust the center of the original to this mark.
20.
Size guide:
Indicates the scannable range of the original.