Filter
Top Products
User Mode
5-23
Operation
Chapter 5
Book mode setting function
Normally, “Book mode” is used in “Auto” setting.
In the following cases, however, set the distance between the stopper and the original.
◆
A hardcover book is scanned
◆
The original height cannot be detected (a waning message “Book Size in Not Detected”
appears)
Set the distance between the stopper and
the original by pressing allow key.
Setting value: 0 to 10 mm
Select the setting value as [0 mm] or [10
mm], [Auto] will appear again.
Then press [Auto] to return to the “Auto”
setting.
Select [OK] to return to the main menu.
NOTE
If the reliable image cannot be made or a warning message appears even though the top
edge of the book is aligned with the stopper, set the distance between the original and the
stopper to [0 mm] and retry scanning.
Stopper
Hardcover
0 to 10 mm
Book
mode
Sheet
mode
OK
Set dist. to stopper (~10)
Auto
0.0 mm
+
0.5 mm
Book
mode
Sheet
mode
OK
Set dist. to stopper (~10)
Auto
0.0 mm
-
0.5 mm