Filter
Top Products
4-1
Chapter 4 ControlLogix PLC Project Configuration
The configuration steps of a ControlLogix project are described this Chapter. These steps are used to
communicate with an ICC ETH-1000 module. It is assumed that the user has basic knowledge in using
RSLogix5000 software to perform the basic configuration steps.
4.1 Adding the 1756 ENBT Module
1. Create a new project in the RSLogix5000 using the proper revision level as the ControlLogix
controller. In this example, the revision level is 16.
2. Right Click on the 1756 Backplane Selection and choose “New Module…”
1
Introduction
2
System Overview
3
Devices to the
Network
4
ControlLogix PLC
Project
Configuration
5
ETH-1000
Configuration
6
Using EtherNet/IP
Explicit Messaging
7
Terminology