Filter
Top Products
3-3
6. Once the new IP address is set, it is very likely (depending on what IP address and Network mask
were assigned to the ENBT module) that the Configuration PC will no longer be able to
communicate with the ENBT module. The IP address of the Configuration PC will need to be
changed to be in the same subnet of the ENBT module before the communication can be re-
established.
3.2 Changing the IP Address of the ICC ETH-1000 Module
The “ICC Gateway Configuration Utility” should be loaded on a Configuration PC that is used to configure
the ICC ETH-1000. The ETH-1000 module can be powered using an USB connection, a Power Over
Ethernet (POE) connection or an external 7- 24V power supply.
Using the USB connection between the Configuration PC and the ICC ETH-1000 is the most straightforward
method to perform the initial configuration of the ICC Module.
1. Launch the “ICC Gateway Configuration Utility” on the Configuration PC and connect a USB cable
to the ICC device.
1
Introduction
2
System Overview
3
Devices to the
Network
4
ControlLogix PLC
Project
Configuration
5
ETH-1000
Configuration
6
Using EtherNet/IP
Explicit Messaging
7
Terminology