Filter
Top Products
4-3
5. Then select the Major Revision level of the ENBT firmware. In the Verification System, the major
revision level of the ENBT module is 2.
6. Enter the proper Name, Slot Location, Revision Level and IP Address of the ENBT module. In the
Verification System, the module name is set at CSC_EIP, the revision firmware level is 2.3, the
module is in Slot 1 of the ControlLogix Chassis, and the IP address is set at 192.168.1.30, matching
the previous configuration.
1
Introduction
2
System Overview
3
Devices to the
Network
4
ControlLogix PLC
Project
Configuration
5
ETH-1000
Configuration
6
Using EtherNet/IP
Explicit Messaging
7
Terminology