Filter
Top Products
+ICF–DataFormat
This Command sets data format of serial interface.
Defined parameters:
<format> <parity> <format> <parity>
1: 8 Data 2 Stop 0: Odd 4: 7 Data 2 Stop 3: Space
2: 8 Data 1 Parity 1 Stop 1: Even 5: 7 Data 1 Parity 1 Stop 4: None
3: 8 Data 1 Stop 2: Mark 6: 7 Data 1 Stop
If <format> is 1, 3, 4 or 6, <parity> will be ignored
+IFC – Flow Control
This Command determines flow control on serial interface.
Defined parameters:
< DCE_by_DTE > < DTE_by_DCE >
0: none 0: none
2: RTS 2: CTS
Appendix AT Commands MIM-G01
Mitsubishi Industrial Modem 8-3
Command Possible answers
AT+ICF? +ICF: <format>,<parity>
OK
Note: current values
AT+ICF=<format>,<parity> OK
Tab. 8-6: +ICF–DataFormat
Command Possible answers
AT+IFC? +IFF: <DCE_by_DTE>,<DTE_by_DCE>
OK
Note: current values
AT+IFC=<DCE_by_DTE>,<DTE_by_DCE> OK
Tab. 8-7: +IFC – Flow Control