Mitsubishi Electronics MIM-G01 Modem User Manual


 
Sending an Express E-Mail
AT Commands MIM-A01 Appendix
8-16 MITSUBISHI ELECTRIC
AT+T Send="Express;..."
AT+T Send="Express; To: Recipient; Dial: Number;From: Sender"
>Subject
>MessageText line#1
>MessageText line#n
><CTRL>+<Z>
This command sends an Express E-Mail or sets the parameters.
When you have closed the command line with <CR/LF>, the modem displays a prompt (>) where
you can specify the subject line you want in your e-mail. The actual message text is entered in the
subsequent lines. To close this message, press <CTRL>+<Z>.
If you skip the message text, the parameters are saved for later use until replaced by new parameters.
Number:
This is the number that must be dialled to connect to the recipient
Enterthe numberexactly asit istobe dialled,includingall countryor area
codes.
Leave out the external call prefix that was indicated in the general para
-
meters.
Recipient:
Express E-Mail address of the recipient, for example,
PAUL+49-30-1234567.
This is inserted in the To: field in the header of the Express E-Mail.
Sender:
Express E-Mail address of the sender, for example,
OTTO+49-30-7654321.
This is inserted in the From: field in the header of the Express E-Mail.
Subject:
Subject line of the message.
This is always generated from the first line that is entered after the
prompt.
MessageText line#n
Other lines of the message text.
Each line is entered at the prompt displayed by the Tixi modem and clo-
sed by <CR/LF>.
Duringsending themodem doesan automaticline breakafter 75charac-
ters by itself. The message text must not contain umlauts
Example:
The send command configures all necessary parameters and sends an Express E-Mail:
AT+T Send="Express; Dial: 1234567; From: JOHN+44-20-7654321;
To: PAUL+44-20-1234567"
>Hello Paul,
>The fan in room 123 in house 12 is not working.
>
>Regards, John.
><CTRL>+<Z>
Short modem reply:
OK